Snap-on 5000-ST Uživatelský manuál stáhnout pdf (Strana 44)

CALIBRATION CHAPTER 5

5-43

Annual calibration is recommended. Calibration by the user is

recorded in memory and voids factory certification. Contact your

authorized CDI sales representative for calibration and repair

services.

If extreme calibration precision is required, refer to Correction

Factors on Test Weights in this chapter.

Mounting Details

Single Transducer Mounting Detail for Calibration

Single transducer calibration requires the use of a reaction stand and

transducer calibration block.

As shown in Figure 5.1, the transducer is secured to the calibration

block with two quick release pins.

• Both pins must be installed for safety and stability of the mount.

• The white mark on the transducer is aligned in the up position.

Figure 5-1: Single Low Torque Transducer Mounting Detail

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 73 74

Žádné komentáře

Snap-on 5000-ST Uživatelský manuál Strana 44